Most jurisdictions require a 4 mil plastic sheet vapor barrier for basement walls against concrete.
Vapor barrier framing a basement wall against concrete.
So there is enough gap for air to flow.
Here are three different types explained.
Of foam against the wall this should not be a problem in your climate.
This is accomplished by installing the vapor barrier to the warm room side of the insulation.
Before framing the walls of your basement install a moisture barrier to prevent water and moisture from entering the wall cavity.
Building codes usually require a vapor barrier 4 mil plastic sheeting on exterior basement walls if the framing is attached to masonry or concrete surfaces or if the wood framing butts up against the outer basement walls.
Or you can leave a 4 inch gap between the studs and concrete wall and probably get away with it.
It is designed to stop moisture in the form of vapour that is inside the house from moving into the walls and forming condensation or ice.
That is if the studs are going to touch the concrete wall.
The water vapor can come through the concrete from the soil or from indoor air that comes in contact with the concrete.
You should then use fiberglass insulation that has a vapor barrier between the studs with the vapor barrier facing in toward the living space.
Hence it must always be located on the warm in winter side of any insulation.
With fiber insulation and a vapor barrier moisture can get trapped in the insulation leading to moldy insulation and decay in the wood framing.
Usually that is right behind the drywall.